IPM Corporation

Home > Product/Technological Information > Hot Runners

Hot Runners

For runner-less, high cycle, low cost production

Hot runner injection molding have the heated and fluidized runner within the mold heater. Not only does it reduce wasted and loss by being runner-less, it increases molding efficiency and makes high precision molding easy under high pressure.

  • ・Customized designing available to meet your needs
  • ・Molds have a simple construction and long life
  • ・Runner-less system reduces waste and loss of plastic
  • ・Minimum pitch between gates: 17.5mm
  • ・Effective against warpage of product
  • ・Available for both engineering plastic and super engineering plastic
  • ・Available to be mounted on up to 30 ton molding machines

Basic Information

Specifications (small valve)

Molding temp ~350°C
Product weight Less than 15g
Gate dia Φ1.0,Φ1.2,Φ1.5
Pitch between gates Minimum 32mm *No limit for semi-hot specs
No. of temp. control 2-points

Purpose/Results

Less material No wasted product material, eco-friendly
Less man power Automation, mass production
Quality Greater precision, unnecessary gate finishing
Cost High cycle, multi-cavity molds

Available Resin

Engineering Plastic

  • Polyamide (Nylon-6): PA-6
  • Polyamide (Nylon-6T): PA-6T
  • Polyamide (Nylon-9T): PA-9T
  • Polyamide (Nylon-12): PA-12
  • Polyamide (Nylon-66) : PA-66
  • Polyphenelene oxide : PPO
  • Polyacetal : POM
  • Polycarbonite : PC
  • Polyethylene terephthalate: PBT
*Except fluoroplastics

Super Engineering Plastic

  • Liquid crystal polymer: LCP
  • Polyphenylene sulfide: PPS
  • Cycloolefin polymer (Zeonex): COP
*Except fluoroplastics